Versions Compared
compared with
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Comment:
Import Macro Repair
If the AMAG server name changes you will need to re-point your Symmetry Advanced Reporting installation to the new server by following the steps below.
Step-by-step guide
- Open Symmetry Advanced Reporting
Image Modified - Once the software is open, click on Options on the left side
...
- Image Added
- On the Options screen click on Datasource, you should seen entries for the Multimax and MultimaxTxn databases
...
- Image Added
- On the right side of the screen click the hamburger (3 horizontal lines) and then click Edit
...
- Image Added
- On the windows that pops up you should see the old server name (uopd-amagserv) in the Server field. Change this to the new server name (uopd-amagserv2)
...
- Image Added
- After changing the server name click Validate and if the server name you typed in is valid you will see a 'Connection valid' with a checkmark in the lower left corner of the Connection window
...
- Image Added
- Do this for all datasources listed.
- Once all of the datasources are edited you should see them with the new server name on the Datasource screen
...
- Image Added
- Go back to your Report Library on the left side and run a report to test and make sure reports are still working.
...
Related articles
Filter by label (Content by label) | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Page Properties | ||
---|---|---|
| ||
|
Table of Contents |
---|